How To Remove Vinyl Siding Bottom

Pull the piece of vinyl siding downward to disengage it from the course below it. 70 water 30 white vinegar makes a great all-purpose vinyl siding cleaner that removes light mold and mildew stains.

How To Replace One Piece Of Vinyl Siding Mid Wall Youtube

Now you can remove the j.

How to remove vinyl siding bottom. Look for a horizontal seam between two courses of vinyl siding. Use a cats paw or other small pry bar to pull the nails from the course you need to remove. Repeat until youre at the ground and then remove the surrounding trim.

Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. Hold them out of. Start by lifting an overlapped piece of vinyl on the top row.

The nails for the first course will be accessible now. Install J channels at doors and windows and under roof eaves and rakes. You will actually start by pulling the bottom of the second course out of the top of the first course.

You will need to remove the bottom course of siding with your removal tool. Ask This Old House general contractor Tom Silva helps a homeowner repair sections of his vinyl siding that have holesSUBSCRIBE to This Old House. Remove the nails one at a time to disconnect the entire length of vinyl.

Remove the nails and the piece of siding. Pull the zip tool downward and out to unhook the bottom lip then slide it along the edge pulling the siding out as you go. Along the tops install J-channel trim with horizontal siding and base trim with vertical siding.

You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down. For a stronger solution. Start cutting with your tin snips at the top interlock and continue toward the bottom of the panel.

Then unzip any pieces above the damaged piece. The vinyl siding zip tool will save you loads of time. Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.

To unlock a section of vinyl siding using only a screwdriver find the end joint insert the screwdriver into the bottom locking edge and pry down and out on the edge until you can grab and pull the bottom edge outward and unlock the corner slide the screwdriver. Insert the siding-removal tool where the panels overlap and pull down and out. Then unzip any pieces above the damaged piece.

Pull the zip tool downward and out to unhook the bottom lip then slide it along the edge pulling the siding out as you go. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. Cut the trim so it is two channel widths longer than the openings width.

How To Replace Vinyl Siding Rona