How To Remove Old Flapper From Toto Toilet

Make sure you turn it the right way and dont push too hard or you can crack the porcelain. Remove The Old Toilet Handle You should now be able to remove the toilet handle by undoing the nuts that hold it in place.

Toto Drake Toilet Replacement Parts

Turn off the water to your toilet.

How to remove old flapper from toto toilet. If water is still left at the base of the drain do not be worried. How to Replace a Toilet Flapper. If you are going to do the project yourself you must take the tank off to get flapper off.

This will be located on the inside of the cistern near the top of the toilet. In this video Ill demonstrate how to replace worn toilet rubber flapper for Toto Drake also works with G-Max Toilet. When flushing the toilets water level would rise in the bowl and slowly drain.

This video shows. Before you unscrew the nuts you have to unhook the water supply. This video involves a flapper smaller than the one on your Toto but the process of removal is the same.

Stop the water source of the toilet and empty the toilet tank by flushing the water in the drain. Go but same unit replacement at box retailer. Turn off the water valve.

If you have a running toilet remove the toilet tank lid and press the toilet flapper down with a screwdriver or any long pin. Gently slide the arms of the flapper off the plastic pegs on the flush valve assembly. A good toilet flapper should be soft have a perfect round rubber in order to seal properly.

Likewise any plumbing jobs you need to shut down the water supply source before you start removing the toilet. Eco versions of Toto toilets have the same model number as the original version but will have an E somewhere after the number. A quick note about Toto model numbers.

How to Remove A Hard Plastic Toilet Flapper. I looked at Toto toilet models online to find one that looked like mine Dartmouth then looked up the full parts list for that model - I think on one of those parts replacement sites - and then looked up the current replacement models. Most toilets including Toto model CST425F and others like it are bolted directly to the closet flange and you can see the bolts on the base of the toilet approximately in the center of the bowl after you pry off the caps.

TOTO now has a Universal Flapper that fits all TOTO toilet models. Basic Toilet Removal Procedure. Toto 2 piece toilet repair with 3 inch flapper.

I got my replacement on Amazon. Removing the Old Flapper. TOTO now has a Universal Flapper that fits all TOTO toilet models.

After you have turned off the water supply successfully open the tank lid. Then put the altered flapper at the middle of the tank drain. Drag the old flapper rising ears out of the fitting after the flapper chain is unhooked from the tank lever.

The only difference between the original and Eco versions is the amount of water they flush 16gpf vs 128gpf - thus they use a different flush valve andor a different flapper. Just unhook the female part of the flapper from the male hook on the flush valve by pulling it across the base of the T and then up the hook and off. So I also have a Toto toilet that doesnt have enough markings and the flapper chain attachment point broke in late March.

A few seconds in you can see how to take the old one off. Take the 3 bolts loose that you see in tank that are brass. Flush toilet and hold the handle down until water stops flowing out of the tank and into the bowl.

This video shows you how to install one. This is a tellta. Remove old flapper from the tank.

If it stops running then the flapper is the problem and you should replace it forthwith. Disconnect flapper chain from trip lever arm note which hole the chain is connected to. Before you can replace a faulty flush valve seal youll need to stop the flow.

Turn tank upside down and unscrew big nut on bottom of tank that will release complete flapper unit.

How To Remove Toto Ultramax Flapper Thu096 Terry Love Plumbing Advice Remodel Diy Professional Forum